ADSL Compliance Compliant with ADSL standards Full-rate ANSI T1.413 Issue 2 and ITU G.dmt (G.992.1) standards Splitterless ITU G.lite (G.992.2) specification ADSL over POTS (Annex A) and ADSL over ISDN (Annex B) DMT modulation and demodulation Full-rate adaptive modem Maximum downstream rate of 8 Mbps Maximum upstream rate of 1 Mbp Tone detection for low power mode Supports splitterless ADSL implementation Supports Dying Gasp ATM Protocols WAN mode support: PPP over ATM (RFC 2364) and PPP over Ethernet (RFC 2516) LAN mode support: bridged/routed Ethernet over ATM (RFC 1483) and Classical IP over ATM (RFC 1577) ATM Forum UNI 3.1 PVC Up to 8 VCs (Virtual Circuits) ATM SAR (Segmentation and Reassembly) ATM AAL5 (Adaption Layer type 5) OAM F4/F5 Bridge Mode Ethernet to ADSL self-learning Transparent Bridging (IEEE 802.1D) Supports up to 128 MAC learning addresses Router Mode IP routing-RIPv2 Static routing DHCP (Dynamic Host Configuration Protocol) Server and Client NAPT (Network Address and Port Translation) NAT (Network Address Translation) ICMP (Internet Control Message Protocol) Simultaneous USB and Ethernet operation (Optional) Security User authentication for PPP PAP (Password Authentication Protocol) CHAP (Challenge Authentication Protocol) Password protected system management Ethernet Interface Compliant with IEEE 802.3 standard 10/100 Mbps auto selection 4* LAN Port USB host Interface(Optional) Compliant with USB Specification, Revision 1.1 USB full speed (12 Mbps) Vendor specific descriptors HTTP Web-based management Firmware upgrade via HTTP Customizable Web pages WAN and LAN side connection statistics Configuration of static routes in the Routing table Configuration of NAT/NAPT Password protected access Selection of Bridge or Router Mode PPP user ID and password Configuration of VCs (Virtual Circuits)